DThe single channel strain gauge amplifier allows the supply and signal amplification of one strain gauge transducer. The connecting of the transducer, which should have a full bridge resistance greater than 300 ohms, can occur in 4-wire-technology or, by using of a long connecting cable or variable length of the connecting cable, in 6-wire-technology. For further evaluation are standard analogue outputs available. The measuring amplifier is installed in a plastic enclosure (IP20) which is intended for the top hat rail mounting.

The amplification can be adapted by an internal precision resistance.

The potentiometers Z (Zero) and G (Gain), which are accessible above the enclosure lid, allow a correction of the calibration.

With the help of an internal resistance, a change of the zero-range can be reached.

With connection in 4-wire technology, the connections 11 and 12 as well as 13 and 14 are internally with Jumper or externally to be bridged. With connection of a transducer which is laid out for 6-wire technology, the connections exist in the transducer. The clamps 3 and 4 are galvanically isolated. To lift the galvanic isolation, the clamps are to be bridged externally.

Note: It is recommended, that the measuring amplifier is to be mounted to neighbouring devices/amplifiers with a distance of mind. 20 mm to avoid a possible influencing.

Dimensions in ''mm'', approx. values These drawings are for information only and not intended for construction purpose.

If requested, a pre-setting of the measuring system or a factory calibration certificate with traceable references can be carried out for an extra charge.

Technical modification according customized requirement are possible on request. Moreover, we deliver Customized special solutions for a lot of measuring tasks in the section pressure, force, distance and tilt measuring using our offered measuring transducer. Do not hesitate to contact us.