The single channel strain gauge amplifier allows the supply and signal amplification of one strain gauge transducer. The connecting of the transducer, which should have a full bridge resistance greater than 300 ohms, can occur in 4-wire-technology or, by using of a long connecting cable or variable length of the connecting cable, in 6-wire-technology. For further evaluation are standard analogue outputs available.

The measuring amplifier is installed in a plastic enclosure (IP20) which is intended for the top hat rail mounting. The amplification can be adapted by an internal precision resistance. The potentiometer Z (Zero) and G (Gain), which are accessible above the enclosure lid, allow a correction of the calibration.

With the help of an internal dip switch, a change of the range of the potentiometer Z (zero) can be reached.