IOLITEI-1XSTG Strain Gauge Amplifier
Fully configurable isolated strain gauge amplifier with EtherCAT bus and software support
About the IOLITEI-1XSTG Strain Gauge Amplifier
IOLITEi-1xSTG is a single channel gauge amplifier with internal quarter-, half- and full-bridge configurations. Low noise voltage and current source excitation are available with freely settable levels. Input ranges span from 50 V to 100 mV. Data is transfered over EtherCAT to a PC running powerful and easy to use DEWESoft data acquisition software.
Features
- Internal bridge completion (quarter & half, 120 & 350 ohm)
- 50 V to 100 mV input voltage ranges
- 20 mA current input range (internal shunt)
- Settable voltage and current excitation (max 400 mW) Low noise, high dynamic performance
- Signal and power isolation from EtherCAT to front-end
- EtherCAT bus, daisy-chaining with single cable up to 50 m device-device
- DEWESoft X3 software support
Applications
- Material strain measurements
- Precise weighting
- Structural load monitoring
Software support: DEWESoft X3, any standard EtherCAT master
Installation: Devices are daisy chained with a standard network cable. It is recommended that the cable is shielded (SFTP, CAT5e) and has a minimum 24 AWG wire thickness. The cable must have 4 wire pairs. The maximum distance node-to-node is 50 m.
Power supply: Passive PoE power injector is neccessary for merging the EtherCAT signal and power into a single cable.
Avez-vous besoin de ce capteur pour votre prochain projet?
Demandez un devis dès aujourd'hui ou laissez vos coordonnées pour recevoir plus d'informations de la part de l'un de nos experts.
Téléchargements de produits
Faites-le à votre façon
Vous ne trouvez pas exactement ce que vous cherchez ? Nous proposons des capteurs et des systèmes de mesure standard, mais nous pouvons également vous aider à concevoir un capteur sur mesure ou une solution de mesure complète. N'hésitez pas à nous contacter pour obtenir des conseils ou un devis.
Parler à un expertSpécifications techniques
Spécifications | Valeur |
---|---|
Accuracy | +/-0,05% +/-2mV |
Adc resolution | 24 bit |
Current limit | 42 mA (max. power: 400 mW) |
Input impendance | 1 (50 V, 10 V range), 20 (1 V, 100 mV range) |
Max. sample rate | 40 kS/s |
Stability | <0.01% |