SG-IP-2G-2P Strain Gauge Amplifiers

Single channel strain gauge amplifier with limit switches und for parallel operating of transducers

About the SG-IP-2G-2P Strain Gauge Amplifiers

The single-channel strain gauge measuring amplifier SG-IP-2G-2P allows supply and signal evaluation of two parallel connected strain gauge transducers with standardized sensitivity. The connection is done in 4-wire technology. For further evaluation standard analogue outputs are available. A test signal and 2 threshold value set-points as well as potential-free switching contacts (max. 30 VDC/0.5 A) for limit value monitoring are available for further evaluation. The measuring amplifier is built-in into a robust EMC die-cast aluminium enclosure (IP65) which is suited for applications in rough and industrial environments.

The amplification/channel of the amplifier can be adapted by an internal precision resistance.

The potentiometers Z (Zero) and G (Gain), which are accessible after removing the enclosure cover, allow a calibration correction.

 

Key features SG-IP-2G-2P

  • Supply voltage 22 - 26 VDC
  • Test signal 5 - 10 V, 2 adjustable threshold value set-points and switching contacts (max. 30 VDC / 0.5 A)
  • EMC aluminium die-cast enclosure (IP65)
  • Dimensions (W x H x D) 175 x 80 x 57 mm

 

Specifications

Number of measuring channels
1 (full bridge resistance >300 Ω)
Supply voltage
22 - 26 VDC
Power consumption
4 W max.
Strain gauge excitation supply
+5 VDC, +10 VDC
Test signal
5 - 10 V
Number of relay switching contacts
2 (max. 30 VDC / 0.5 A)
Input resistance
>3 MΩ
Max. input sensitivity
100 mV/V at 10 VDC excitation supply
Non-linearity
±0.05 % FSO
Electrical connection
EMC cable gland on internal terminal block
Enclosure
EMC aluminium die-cast enclosure (IP65)
Dimension (W x H x D)
175 x 80 x 57 mm
Weight
750 g
Temperature, storage
-20 to +60 °C
Temperature, operating
-20 to +50 °C
  • Follow us: