About the SG-KS-4P Strain Gauge Amplifiers
This single channel strain gauge amplifier SG-KS-4P allows supply and signal amplification of up to 4 transducers with normalized signal. The transducer connection, which should have a full bridge resistance greater than 300 Ohms, can be done in 4-wire technology. For further evaluation standard analogue outputs are available. The measuring amplifier is built into a plastic enclosure (IP20) which is intended for top hat rail mounting. The amplification can be adapted by an internal precision resistance. The potentiometers Z (Zero) and G (Gain), which are accessible via the enclosure cover, allow a calibration correction. By means of an internal dip switch, a change of the potentiometer Z (zero) range can be achieved. To allow a zero range shift, a basic load / tare can be suppressed by a resistance electrically.
Key features SG-KS-4P
- Supply voltage 10 - 18 VDC / 18 - 30 VDC
- Analogue output 0 - 10 V / ±10 V / 4 - 20 mA
- Plastic enclosure (IP20) for DIN-top hat rail mounting
- Dimensions (W x H x D) 152 x 73.2 x 118.2 mm