About the SG-KP Strain Gauge Amplifiers

This single channel strain gauge amplifier SG-KP allows the supply and signal amplification of a strain gauge transducer. The connecting of the transducer which should have a full bridge resistance greater than 300 ohms, can be done in 4-wire-technology or by using a long connecting cable in 6-wire-technology. For further evaluation standard analogue outputs are available.

The measuring amplifier is installed into a plastic enclosure (IP20) which is intended for the top hat rail mounting.

The amplification can be adapted by an internal precision resistance.

The potentiometers Z (Zero) and G (Gain), which are accessible above the enclosure cover, allow a correction of the calibration. By means of an internal resistance, a change of the zero-range can be achieved.

Key features SG-KP

Supply voltage 10 - 18 VDC / 18 - 30 VDC
Analogue output 0 - 10 V / ±10 V / 4 - 20 mA
Plastic enclosure (IP20) for DIN-top hat rail mounting
Dimensions (W x H x D) 23 x 99 x 115 mm

Behöver du den här sensorn till ditt nästa projekt?

Begär en offert eller lämna dina uppgifter för att få mer information från en av våra experter.

Prata med en expert

Produktnedladdningar

Få det på ditt sätt

Inte exakt vad du letar efter? Vi erbjuder standardsensorer, men kan också hjälpa dig med en komplett skräddarsydd lösning. Kontakta oss för rådgivning eller budgetprissättning.

Prata med en expert