SG-IP-4P Strain Gauge Amplifiers
Single channel strain gauge amplifier for parallel operating of up to 4 transducers
About the SG-IP-4P Strain Gauge Amplifiers
This single channel strain gauge measuring amplifier SG-IP-4P allows supply and signal evaluation of up to four transducers with normalized sensitivity and a strain gauge full bridge greater than 300 ohms. Input and output are galvanically isolated. The connection is done in 4-wire technology. For further evaluation standard analogue outputs are available. The measuring amplifier is built-in into a robust EMC die-cast aluminium enclosure (IP65) which is suited for applications in rough and industrial environments.
The amplification can be adapted by an internal precision resistance.
The potentiometers Z (Zero) and G (Gain) which are accessible after removing the enclosure cover, allow a calibration correction.
By means of an internal dip switch, a change of range of the potentiometer Z (zero) can be reached. To allow a zero range shift, a basic load / tare can be suppressed by a resistance electrically.
Key features SG-IP-4P
- Supply voltage 10 - 30 VDC
- Analogue output 0 - 10 V, ±10 V, 4 - 20 mA
- EMC aluminium die-cast enclosure (IP65)
- Dimensions (W x H x D) 220 x 120 x 80 m
Behöver du den här sensorn till ditt nästa projekt?
Begär en offert eller lämna dina uppgifter för att få mer information från en av våra experter.
Produktnedladdningar
Få det på ditt sätt
Inte exakt vad du letar efter? Vi erbjuder standardsensorer, men kan också hjälpa dig med en komplett skräddarsydd lösning. Kontakta oss för rådgivning eller budgetprissättning.
Prata med en expertTekniska specifikationer
| Specifikation | Värde |
|---|---|
| Analogue output | 0 - 10 V, ±10 V, max. 1 mA (short-period short-circuit proof) 4 - 20 mA, max. 500 Ω |
| Dimension (b x h x d) | 220 x 120 x 80 mm |
| Electrical connection | EMC cable gland on internal terminal block |
| Enclosure | EMC aluminium die-cast enclosure (IP65) |
| Input resistance | >3 MΩ |
| Isolating proof voltage input to output | 200 V, higher isolated proof voltage on request |
| Limit frequency (-3 db) | 1 kHz, optional up to 30 kHz |
| Max. input sensitivity | 100 mV/V at ±5 VDC excitation supply |
| Non-linearity | ±0.05 % FSO |
| Number of measuring channels | 1 (full bridge resistance >300 Ω) |
| Power consumption | 8 W, max. |
| Strain gauge excitation supply | ±2.5 VDC, ±5 VDC |
| Supply voltage | 10 - 30 VDC, electronics protected against voltage reversal |
| Temperature, operating | -20 to +50 °C |
| Temperature, storage | -20 to +60 °C |
| Weight | 1650 g |