20HP Multi-turn Potentiometer
Multi-turn Wirewound Bushingmount type
Nyckelfunktioner
- Wirewound
- Dimensions (mm) DxL: 20×18 / 20×25.5
- Resistance range (ohm): 100Ω -50kΩ / 100Ω -100kΩ
- Linearity (±%): 0.3 to 0.2 /0.2 to 0.1
- Mechanical travel (+10° 0°): 1,800 / 3600
- Electrical travel (±5°): 1,800 / 3600
About the 20HP Multi-turn Potentiometer
The 20HP is a precision multi-turn potentiometer with an outer diameter of 20mm. Servomount type and with limit-switch is also available.
Features Multi-turn potentiometer 20HP-5S
- Wirewound
- Dimensions (mm) DxL: 20×18
- Standard resistance range (ohm): 100Ω -50kΩ
- Independent linearity (±%): 0.3 to 0.2
- Mechanical travel (+10° 0°): 1,800
- Electrical travel (±5°): 1,800
Features Multi-turn potentiometer 20HP-10S
- Wirewound
- Dimensions (mm) DxL: 20×25.5
- Standard resistance range (ohm): 100Ω -100kΩ
- Independent linearity (±%): 0.2 to 0.1
- Mechanical travel (+10° 0°): 3600
- Electrical travel (±5°): 3600
Special Specifications Available
3turn type (S20HP3S), lower resistance values (10Ω, 20Ω, 50Ω), extra taps (available up to 1 tap), multiganged (available up to 2 gangs), shaft with front and rear extension (rear shaft with 2mm dia. and 10mm length), shaft dia. (ø6.35mm) · bushing with inch dimensions, special machining on the shaft, simple sealed housing (expect servomount type), slippingclutch incorporated type (S20HP10S1782, 20mN·m~60mN·m), with a limitswitch adaptor, with pin terminals for p.c. board (20HP-5P, 20HP-10P).
Behöver du den här sensorn till ditt nästa projekt?
Begär en offert eller lämna dina uppgifter för att få mer information från en av våra experter.
Produktnedladdningar
Få det på ditt sätt
Inte exakt vad du letar efter? Vi erbjuder standardsensorer, men kan också hjälpa dig med en komplett skräddarsydd lösning. Kontakta oss för rådgivning eller budgetprissättning.
Prata med en expertTekniska specifikationer
| Specifikation | Värde |
|---|---|
| (within 5kΩ): (±0.25%) (±0.15%) | |
| Precision Class: ±0.2% ±0.1% | |
| Dielectric strength | 1 minute at 1,000 V.A.C. |
| Electrical travel | 360º Xn ±5º (n: No. of turns) |
| Independent linearity tolerance (5-turn 10-turn) | Standard Class: ±0.3% ±0.2% |
| Insulation resistance | Over 100 MΩ at 1,0000 V.D.C. |
| Mass | Approx. 25g (5-turn), Approx. 30g (10-turn) |
| Max. practical resistance value | 100kΩ (5turn), 150kΩ (10turn) |
| Max. working voltage | 900V |
| Mechanical travel | 360º Xn + 1 0 (n: No. of turns) |
| Noise | Within 100O E.N.R. |
| Power rating | 1.0W (5-turn) 2.0W (10-turn) |
| Resist. temp. coefficient of wire | ±20p.p.m./ºC |
| Shaft dia. (mm) | 6 |
| Standard resistance range | 100Ω to 50kΩ (5turn), 100Ω to 100kΩ (10turn) |
| Starting torque | Within 5mN·m (50gf·cm) (Bushingmount type), Within 3mN·m (30gf·cm) (Servomount type) |
| Stopper strength | Approx. 0.9N·m (9kgf·cm) (Bushingmount type), Approx. 0.6N·m (6kgf·cm) (Servomount type) |
| Total resistance tolerance | Standard Class ±3%(H), Precision Class ±1%(F) |
Relaterade produkter
Behöver du något annat?
20HPS Multi-turn Potentiometer
- Measuring range 3, 5 or 10
- Resistance range 20 Ω to 100 kΩ
- 20 mm outer diameter
22HP Multi-turn Potentiometer
- Measuring range 1 to 8 turns
- Standard dimensions 22×19 mm
- Lowest-cost multi-turn potentiometer
25HP Multi-turn Potentiometer
- Measuring range 3, 5, 10, 15 or 20 turns
- Standard resistance range 100Ω -100kΩ
- Independent linearity ±0.3% to ±0.1%