VibroMatrix® InnoLogger®

Monitoring and Logging Instrument (Software Instrument)

About the VibroMatrix® InnoLogger® Software

The InnoLoggers are able to log and monitor signals or characteristics. The logged data can be used for further analysis with external programs.

The following settings allow a suitable signal processing:

  • Free filter adjustment 0,1 to 40000 Hz (when using InnoBeamer X2)
  • SI- and imperial units for each measurand
  • 25 characteristics
  • 2 alarms with alarm delay

Automated operation is supported by an external trigger: Thus, the start of the InnoLoggers’ measurement can be controlled externally. Additionally, data logging can be prevented acc. to adjustable rules, e.g. if you already acquired enough data.

In combination with event annunciators, measured values and alarm states can be presented in a colored and enlarged extra display or be sent via e-mail. Alarm states can control radio switches and digital outputs like e.g. relays and thus are able to switch electrical alarm lamps or acoustic signaling devices.

The e-mail annunciator additionally allows to send logged data automated.

Applications InnoLogger®

Vibrations are caused by rotating parts or impulse-like loads, e.g. by a vibratory pile driver in the construction-field. In numerous vibration standards significant vibration characteristics and limit values are defined for a reliable evaluation of the vibration situation.

The InnoPlotters measure these vibration characteristics, display their trend graphically and monitor them when required. Thus, they are especially convenient for longer test sequences. Weak spots in the continuous operation become obvious, the success of counter measures is proven and the compliance of limits is controlled.

Requirements for using InnoLogger®

  • Microsoft Windows operating system
  • Windows XP or newer (32-bit and 64-bit)
  • VibroMatrix measurement system (measurement amplifier InnoBeamer required)
  • Follow us: