ALF205 Donut Ring Force Sensor

Ideally suited for engineering force measurements (centre safety testing of cables, rods and bolts)

About the ALF205 Donut Ring Force Sensor

The ALF205 is ideally suited to engineering force measurements including through centre safety testing of cables, rods and bolts. It is designed for easy installation, usually between two flat faces bearing on its loading rings, either unattached or with retaining spigots positioned in the centre hole. Alternatively tensile load transfer can be achieved via a tie rod assembly through the centre hole. In this way the loadcell can indirectly measure tensile loads in a “fail-safe” mode.

We are happy to design variants of this loadcell to meet your specific requirements. Versions can be manufactured for operation up to +250°C. Please consult our engineering department.

Geometry: Axial strain cylinder in a sealed case, with raised end load bearing faces and hole right through. For use in compression or in fail-safe tensile applications.

Features ALF205

  • Full load range: 1MN, 2MN
  • Dimensions (mm): OD165 x ID64 x H165
  • Non-lin./hysteresis: 0.5/0.5% RL
  • Hardened stainless steel body
  • Very high structural load limit

Connections
The loadcell is fitted with 2 metres of PVC insulated 4 core screened cable type 16-2-4C or a 4 pin Binder 723 series chassis plug.

  • Excitation + = Red or pin 1 Signal + = Yellow or pin 3 Screen = Orange
  • Excitation - = Blue or pin 2 Signal - = GreeEn or pin 4

The screen is not connected to the loadcell body.

Specifications

Measurement range
1MN, 2MN
Non-linearity - Terminal
±0.5% RL
Hysteresis
±0.5% RL
Creep - 20 minutes
±0.05% AL
Repeatability
±0.02% RL
Rated output - Nominal
1.2 mV/V
Rated output - Rationalised
1.0 mV/V
Load direction
Compression
Rationalisation tolerance
±0.5% RL
Zero load output
±4% RL
Temperature effect on rated output per °C
±0.005% AL
Temperature effect on zero load output per °C
±0.03% RL
Temperature range - Compensated
-10 to +50°C
Temperature range - Safe
-10 to +80°C
Excitation voltage - Recommended
10V
Excitation voltage - Maximum
20V
Bridge resistance
700 Ω
Insulation resistance - Minimum at 50Vdc
500 MΩ
Overload - Safe
50% RL
Overload - Ultimate
400% RL
Sealing
IP65
Weight - Nominal (excluding cable)
18 to 19kg
  • Follow us: