XPM10 Miniature Pressure Sensor

---

Key features

• Measuring ranges from 0 ... 1 bar to 0 ... 350 bar
• Absolute and relative pressure
• Linearity deviation 0.25 % (0.35 % for 1 bar)
• Linearity up to ±0.25% F.S
  
• Very low mass, approximately 20 grams without cable
  (dependent on options)
• Supply voltage 10 VDC
• Flush diaphragm
• Insensitive to installation torque
• Connection thread M10 x 1
• For static and dynamic applications
• High Level Tension Output Available
• Low Installation Torque Sensitivity

---

General Information

The XPM10 is a miniature metric threaded pressure sensor designed to measure static and dynamic bridges in a wide range of applications. It is also suitable for harsh environmental conditions. It is made of stainless steel (titanium optional) and is available in measurement ranges from 1 bar to 350 bar. The XPM10 uses SanShift™ technology, which largely eliminates zero deviations caused by torques during installation.

The XPM10 pressure transducer is also available with an integrated amplifier. The following amplifiers are available:
A1: output signal 0.5 ... 4.5 V
A2: Output signal ±5 V
A3: Output signal 4 ... 20 mA

Features

• Measuring ranges from 0 ... 1 bar to 0 ... 350 bar
• Absolute and relative pressure
• Linearity up to ±0.25% F.S
• Very low mass, approximately 20 grams without cable(dependent on options)
• Output signal 10 mV/V (5 mV/V for 1 bar)
• Supply voltage 10 VDC
• Optionally with integrated electronics
• Flush diaphragm
• Insensitive to installation torque
• Connection thread M10 x 1
• For static and dynamic applications
• High Level Tension Output Available
•  Low Installation Torque Sensitivity
• Stainless steel construction
• Optional output 4 ... 20 mA 2-wire
• Optional IP67

Applications

• Hydraulic control processes
• Explosion test benches
• Brake pressure
• Laboratory and research

---