FCP12AC Singleturn Drehgeber

Kostengünstiges Potentiometer mit nach hinten verlängerten Pin-Anschlüssen, für die Montage über Außengewinde

About the FCP12AC Single-turn Potentiometer

The FCP12AC is a low-cost 1-turn potentiometer with rear extended pin terminals.

Features FCP12AC- Conductive plastic (Bushingmount)

  • Conductive plastic
  • Dimensions D x L (mm): 13 x 10
  • Standard Resistance Range 1 to 10 kilo ohm
  • Independent Linearity (± %): 2.0 to 1.0
  • Mechanical travel (+10° 0°): 360°
  • Electrical travel (±5°): 300° ±5°

Special Specifications Available

Extra taps (available up to 1 tap), shaft with front and rear extension (rear shaft with 1mm dia. and 10mm length), with stopper (rotating angle becomes 310º and stopper strength is 0.3N·m [3kgf·cm]), special electrical travel, shaft dia. (ø3.175mm) bushing with inch dimensions, special machining on the shaft.

Produktspezifikationen

Standard Resistance Values
1k, 2k, 5k, 10 k (O)
Special Practical resistance Values
500, 20k, 50k, 100k (O)
Total resistance tolerance
Standard Class ±15% (L) Precision Class ±10% (K)
Independent linearity tolerance
Standard Class ±2.0% precision Class ±1.0%
Resolution
Essentially infinite
Output Smoothness
Within 0.1% against input voltage
Contact Resistance Variation
Within 3% C.R.V.
Power Rating
0.2W
Electrical Travel
300º ±5º
Mechanical Travel
360º (Endless)
Insulation Resistance
Over 1,000MO at 500 V.D.C
Dielectric Strength
1 minute at 500 V.A.C.
Starting Torque
Within 2mN·m (20gf·cm)
Resistance temp. coefficient
±400p.p.m./ºC
Mass
Approx. 8g
Starting Torque
Within 2mN·m (20gf·cm)